6/11/2023 0 Comments Lightburn cut settings![]() ![]() What we did here was to duplicate the outer edge of the design, and then adjust that with the new settings we made up. This setting will help you generate your desired sticker outline. Later, this is what your laser cutter will go through to cut out your designs. You will not have to use the traced images for your Print & Cut experiment, however they are needed to make an offset outline. Import the digital version of your stickers, and make sure that the LightBurn Camera is turned on and is recording in your machine.īefore you start the Print & Cut Wizard, trace the image with the shown option.Īdjust the settings until you are happy with the preview result. These will make sure that the Camera will perform aligning well in the later steps.Īfter positioning your sticker sheet, let's head back to LightBurn Software. We will explain shortly why!Īn important element that you must have on your sticker sheet is two crossmarks on extreme ends of the sheet, so make sure these are on the printed out version of your workpiece before heading into using the feature. You don't have to be exact with aligning the sheet in the center, or aligning it to any corners. After that, place it on the honeycomb bed of your laser cutter. To begin using this feature, first print your stickers or labels on an adhesive sheet. ![]() For advice on the topic, see our help page right here. One of the most important things is that you have set up your LightBurn Camera inside an enclosureto the right height in comparison to your laser cutter's structure. ![]() There are a couple of things to check before heading in to try out this feature. Make cutting out custom shaped and sized labels or stickers a piece of cake: Print & Cut in LightBurn Software is a practical tool to save you time.
0 Comments
Leave a Reply. |